Electrification Specialist • San Jose

Gas to Heat Pump Water Heater Conversion in San Jose, CA

Updated • By Joseph Castro, Owner • Licensed CSLB #1008381

We retire San Jose gas water heaters and replace them with ENERGY STAR heat pump units — our licensed in-house electrician runs the 240V/30A circuit, we cap the gas and seal the old flue, and we pull the City of San Jose permit in one coordinated job.

  • Licensed CSLB #1008381
  • In-House Licensed Electrician
  • 240V/30A Circuit Included
  • SJ Building Permit Pulled
  • Rebate Paperwork Help
  • Zero-NOx Electric Option
Heat pump water heater replacing a gas tank in a San Jose garage

What this service covers

Going from gas to a heat pump water heater is an electrification project, not a swap. The water heater itself is the easy part — the electrical circuit, air volume, and condensate are what decide whether a San Jose home converts in a day or needs a panel upgrade first.

  • Panel load calculation (NEC 220.83) before anything is ordered
  • Dedicated 240V/30A circuit run by our licensed in-house electrician
  • Gas supply shut off, capped, and pressure-tested at the appliance stub
  • Old B-vent flue removed or sealed at the roof/wall
  • Heat pump unit sized 50, 65, or 80 gallons to your household
  • Condensate line to a drain or condensate pump
  • Seismic strapping and expansion tank per CPC
  • Ducting or louvered door when air volume is tight
  • City of San Jose building/electrical permit and final
  • San Jose Clean Energy and TECH Clean California rebate paperwork

Conversion Day in San Jose: What Happens, In Order

1

Shut off & drain

Gas off, old tank drained and removed. Gas line capped and leak-tested before we leave the area.

2

Run the circuit

Our electrician installs the 30A double-pole breaker and runs 10-gauge wire to the heater location.

3

Set & plumb

Unit set on a pad, strapped, connected with expansion tank, T&P discharge, and condensate line.

4

Commission & inspect

Set mode (heat pump / hybrid), confirm amperage draw, then meet the San Jose inspector.

San Jose Conversion Inspection Checklist

Conversions fail inspection in predictable ways. This is the San Jose checklist we close out every job against.

  • Gas stub capped with an approved fitting and tested
  • Abandoned flue sealed so no draft or water enters
  • Breaker size matches the manufacturer nameplate
  • Disconnect within sight of the unit where required
  • Condensate terminates at an approved receptor
  • Two seismic straps at upper and lower thirds
  • Expansion tank installed on the cold side
  • Air volume or ducting meets the install manual

Is Your San Jose Home Ready? 4-Point Readiness Check

Before quoting, we check the four things that decide your scope. Text photos to (408) 470-0191 and we'll grade each one.

1

Panel capacity

Many 1950s–60s Blossom Valley and West San Jose homes still have 100A panels. Most can take a 30A breaker; some need a 120V plug-in unit or a panel upgrade.

2

Space & air volume

Heat pumps pull heat from surrounding air. Garages are ideal; interior closets need a vented door or ducting.

3

Condensate route

Units make water. We need a floor drain, laundry standpipe, or a small condensate pump.

4

Noise & location

Units run near refrigerator volume. We keep them away from bedrooms in Rose Garden bungalows with interior tanks.

Why One Crew Matters: Plumber + In-House Electrician

  • Our licensed electrician is on staff — no subcontractor scheduling gaps
  • Breaker, wire, and disconnect sized to the unit's nameplate (typically 30A)
  • Panel upgrade coordination with PG&E when a 100A service is maxed
  • One permit, one inspection visit for plumbing and electrical
  • Gas cap and pressure test done by the same team
  • Joseph Castro, owner, reviews every conversion scope

Gas-to-Heat-Pump Factors Specific to San Jose

San Jose is served by PG&E for delivery and San Jose Clean Energy (SJCE) for electric generation, so your conversion runs on a cleaner grid mix and may qualify for SJCE incentives when funding is open. Older homes in Rose Garden (95126) and Willow Glen often have interior tanks; Silver Creek (95138) and Evergreen garages are the simplest conversions.

  • San Jose Clean Energy heat pump water heater incentives (check current availability)
  • TECH Clean California contractor-applied rebates
  • City of San Jose Reach Code favors all-electric in new construction
  • BAAQMD Rule 9-6: zero-NOx water heater requirement starting 2028
  • Blossom Valley (95123/95136): frequent 100A panel checks
  • Rose Garden (95126): interior closets needing vented doors
  • Silver Creek (95138): roomy garages, one-day installs
  • PG&E E-TOU rates — we set timers to heat off-peak

Read our Bay Area 2028 water heater law guide for the BAAQMD timeline.

City Overview • Santa Clara County

Gas to Heat Pump Water Heater Conversion in San Jose, CA — At a Glance

San Jose is our home market — we run 15+ water heater jobs per week across the 95110–95148 footprint. Every era of San Jose housing has its own quirks: 1920s Willow Glen bungalows almost always need gas-line upsizing for tankless, Almaden Valley slab-on-grade garages have their own seismic strapping approach, and 1970s Evergreen tract homes commonly need code-correction work on venting and expansion tanks during any replacement.

Neighborhoods routinely serviced from our San Jose dispatch — spokes represent typical response corridors, not exact geography.

Permits pulled with

San Jose Development Services

Utility

PG&E gas & electric

Local climate

Mediterranean — mild winters, dry summers; garage tanks rarely freeze

Housing stock we work on

1920s Willow Glen craftsman • 1950s Cambrian ranch • 1970s Almaden tract • modern North SJ townhome

ZIP codes covered

  • 95110
  • 95112
  • 95116
  • 95118
  • 95120
  • 95124
  • 95125
  • 95126
  • 95128
  • 95129
  • 95131
  • 95135
  • 95148

Nearby landmarks

Santana Row • Downtown SJ • Almaden Lake

See all San Jose water heater services →

San Jose — Frequently Asked Questions

  • Which San Jose ZIP codes do you cover?

    Every San Jose ZIP from 95110 through 95148, including 95110 Downtown, 95112 Japantown, 95116 East San Jose, 95118 Cambrian, 95120 Almaden Valley, 95124 Willow Glen–Cambrian, 95125 Willow Glen, 95126 Rose Garden, 95128 Burbank–Valley Fair, 95129 West San Jose, 95131 Berryessa, 95135 Evergreen, and 95148 Silver Creek.

  • Do San Jose water heater jobs require a permit?

    Yes. San Jose Development Services requires a plumbing permit for every water heater replacement and installation — including like-for-like tank swaps. Inspection covers CPC 507.2 seismic strapping, expansion tank, T&P discharge, combustion air, and vent clearance. We pull the permit and coordinate the inspection.

  • How fast can you get to my San Jose neighborhood?

    Willow Glen, Cambrian, Rose Garden, and Downtown typically see a tech within 2–4 hours. Almaden Valley, Evergreen, Berryessa, and Silver Creek are on 3–5 hour windows depending on the day. Same-day is available across all 13 ZIPs when scheduling allows.

  • Do you understand San Jose's older housing stock?

    Yes. We work daily in 1920s Willow Glen craftsman bungalows with half-inch black-iron gas mains, 1950s Cambrian ranches with atmospheric-vent tanks in closets, 1970s Almaden tract homes with garage installs, and modern North San Jose townhomes with tankless conversions. Each era needs a different scope.

How to Stack Rebates on a San Jose Conversion

Incentives change often. Here's the order we follow so you don't miss one.

1

Check program status

We confirm which SJCE and TECH Clean California programs are funded the week you book.

2

Reserve before install

Some programs require pre-approval; we submit before conversion day when needed.

3

Federal tax credit

Keep the itemized invoice and AHRI certificate for the IRS 25C energy efficient home improvement credit, if available for your tax year.

Gas Tank vs Heat Pump vs Hybrid Mode: San Jose Comparison

Electrical work

Keep gas tank: None

Heat pump water heater: New 240V/30A circuit

Heat pump + 120V plug-in: Existing 120V outlet

Efficiency (UEF)

Keep gas tank: ~0.6–0.7

Heat pump water heater: 3.3–4.0

Heat pump + 120V plug-in: ~3.0+

Recovery speed

Keep gas tank: Fast

Heat pump water heater: Moderate; hybrid mode boosts

Heat pump + 120V plug-in: Slower; size up

2028 BAAQMD

Keep gas tank: New gas units must be zero-NOx (75,000 BTU/hr or less)

Heat pump water heater: Compliant

Heat pump + 120V plug-in: Compliant

Best fit in SJ

Keep gas tank: Short-term repairs

Heat pump water heater: Most garages

Heat pump + 120V plug-in: Maxed 100A panels

Not sure which path fits your situation?

Call (669) 337-9311Get Phone Estimate

Heat Pump Units We Install in San Jose

Rheem ProTerra, A. O. Smith Voltex, and Bradford White AeroTherm are our main conversion units; we also install 120V plug-in models when panel capacity is tight. See heat pump water heater installation in San Jose and hybrid water heater installation.

Service hub

Broader gas to heat pump water heater conversion coverage in San Jose.

Closest city pages

Nearest city hubs by drive time from San Jose.

Frequently asked questions

Most full-size heat pump water heaters need a dedicated 240V/30A circuit. Our licensed in-house electrician installs it as part of the conversion. If your panel is full, a 120V plug-in model can avoid a panel upgrade.

Ready to Go Electric in San Jose?

Call (669) 337-9311 or text photos of your water heater and electrical panel to (408) 470-0191. We'll check your panel and plan the conversion.

  • Licensed CSLB #1008381
  • Bonded & Insured
  • Open 24/7

Navien Service Specialist · Rinnai PRO · Noritz Certified