Water Heater Repair in Campbell, CA

Efficient Water Heaters, Inc. provides water heater repair in Campbell, CA for gas, electric and tankless units. Most Campbell calls come down to hard-water sediment, a worn ignition part or a dripping relief valve. We test before we replace anything, and we answer the phone 24 hours a day.

Call (669) 337-9311 · Get a phone estimate

Licensed CSLB #1008381 · Bonded & Insured · Open 24/7 · Navien Service Specialist · Rinnai PRO · Noritz Certified

Efficient Water Heaters technician testing a gas water heater on a repair call
Testing the burner and gas control on a Campbell repair call.
Water heater seismic straps, venting and relief valve checked during service
Straps, relief line and venting get checked on every visit.
Tank, tankless and heat pump water heaters shown side by side
Tank, tankless and heat pump heaters need different repairs.

Why do water heaters in Campbell need repair?

Campbell gets its tap water from San Jose Water, and a large share of that supply is pumped from local groundwater wells. San Jose Water's 2025 water quality report lists an average of 16.8 grains per gallon for its groundwater, with a range of 10.2 to 26.4 grains (San Jose Water 2025 report). That is hard water, and when it is heated the minerals drop out as sediment.

Sediment is behind many of the repairs we make in Campbell. It insulates the bottom of a gas tank, so the burner runs longer and the tank pops or rumbles. In an electric tank it buries the lower element until it burns out. In a tankless unit it coats the heat exchanger and trips a scale or overheat code.

Campbell water heater problems we fix most

These are the faults we find most often in Campbell homes, from ranch houses off Hamilton Avenue to condos near the Pruneyard.

Common Campbell water heater faults and what we do
What you noticeWhat we usually findWhat we do
Popping, rumbling or cracklingHard-water sediment over the burnerFlush the tank, then check the burner and flue
Pilot will not stay litWeak thermocouple or dirty pilotClean the pilot assembly or replace the thermocouple
Electric tank only warmLower element scaled over or burned outTest both elements and thermostats, replace the failed one
Drip at the relief valve pipeHigh house pressure or a tired T&P valveMeasure pressure, add an expansion tank, replace the valve
Tankless shows a code and shuts offScale, blocked air filter or ignition faultRead the code, descale or clean, replace the part
Rusty or smelly hot waterSpent anode rodInspect and replace the anode rod

Our Campbell repair process, step by step

We keep the visit simple so you know the cost before any work starts, whether you live near Downtown Campbell or off San Tomas Aquino Road.

  1. Text a photo of the heater, its model plate and any error code to (408) 470-0191 from anywhere in 95008.
  2. We give a phone estimate and a time window for your 95008 address.
  3. On site near Campbell Avenue or the Pruneyard, we confirm the fault with gas, voltage, flow and pressure tests.
  4. You approve the price, then we repair it with a matching part.
  5. We restart the heater and check the temperature, relief valve, straps, vent and the 18-inch platform on garage gas units.

Is it safe to keep using a water heater that is acting up?

Turn the heater off and call for help if you smell gas, see water coming from the tank itself, or hear the relief valve spraying. For gas, leave the house and call PG&E or 911 from outside first. For a leak, close the cold-water valve on top of the heater and switch off the gas or the breaker.

A heater that makes noise, gives lukewarm water or needs its pilot relit is not an emergency, but it will get worse. A tank that runs hot for hours to make up for sediment also costs more to run.

Repair or replace: three questions we ask in Campbell

Not every heater is worth fixing. The Department of Energy puts the life of most storage water heaters at 10 to 15 years, and many tankless units past 20 years (Energy Saver Guide). We look at three things before we suggest anything.

  • How old is the heater, going by the serial number on the plate?
  • Is the leak from a fitting we can fix, or from the steel tank itself after years of San Jose Water hardness?
  • Has this heater needed other repairs in the last couple of years, and does it still meet the 18-inch platform rule?

If a replacement makes more sense, we can do that too. The City of Campbell water heater checklist calls for a gas heater in a garage to sit on an 18-inch platform (City of Campbell checklist). See our Campbell water heater replacement page for permit details.

How often should a Campbell water heater be flushed?

On hard San Jose Water supply, a tank that is never drained can lose real capacity to sediment within a few years. The Department of Energy suggests draining about a quart from a tank every 3 months and setting the thermostat to 120°F (Energy Saver Guide). A lower setting also slows scale.

Tankless owners in Campbell should plan on descaling about once a year, more often on the hardest wells. We can add isolation valves during a repair so later flushes take less time. California also requires 2 seismic straps on a water heater (California Seismic Safety Commission), and we fix missing or loose straps while we are there.

Water heater repair across Campbell 95008

We repair water heaters all over Campbell, from Downtown Campbell and Campbell Avenue to homes along Winchester Boulevard, Bascom Avenue and San Tomas Aquino Road. Our shop at 240 Bayview Ave in San Jose reaches Campbell by Highway 17 and Highway 85, and we often work near the Los Gatos Creek Trail.

Campbell water heater repair FAQs

How much does water heater repair cost in Campbell?

Water heater repair cost in Campbell depends on the failed part, the type of heater and how easy it is to reach. Efficient Water Heaters, Inc. finds the fault first and gives you the price before any work. Text photos of the heater and model plate to (408) 470-0191 for a phone estimate.

Why is my water heater making a popping noise in Campbell?

Popping usually means hard-water sediment has built up over the burner, and small pockets of water under it are boiling. Campbell's groundwater supply averages 16.8 grains of hardness, so this is common. A flush often quiets the tank, and we check the burner while we are there.

Is a tankless water heater better than a tank for Campbell hard water?

Neither is immune. On San Jose Water groundwater, a tank collects sediment and a tankless unit collects scale in its heat exchanger. A tankless heater lasts longer and shows error codes, but it needs yearly descaling in Campbell. We repair Navien, Rinnai, Noritz and tank brands alike.

Do you offer emergency water heater repair in Campbell?

Yes. Our phone is answered 24/7. If you have a leak or no hot water anywhere in 95008, call (669) 337-9311 and we will tell you how to make the heater safe and when we can be there. If you smell gas, leave the house and call PG&E or 911 first.

How long does a water heater repair take?

Most tank repairs in Campbell take 1 to 2 hours once we have the part. A gas control valve or a tankless circuit board may need to be ordered, which can add a day. From our San Jose shop we reach Campbell quickly by Highway 17 or Highway 85.

How often should I drain my water heater in Campbell?

Drain about a quart every 3 months, as the Department of Energy suggests, and do a full flush once a year on hard San Jose Water supply. If a Campbell tank has never been flushed and is over 10 years old, call us first, since old sediment can clog the drain valve.

Get a phone estimate for your Campbell water heater repair

Call (669) 337-9311 or text photos of your water heater and model plate to (408) 470-0191. We also repair water heaters in nearby San Jose, Santa Clara and Sunnyvale. You can check CSLB #1008381 on the state license site.

Call (669) 337-9311 · Get a phone estimate · Efficient Water Heaters, Inc. on Google Maps