Water Heater Repair in Redwood City, CA
Efficient Water Heaters, Inc. provides water heater repair in Redwood City, CA for gas, electric and tankless units. Redwood City's soft Hetch Hetchy water means less sediment than South Bay homes see, so most repairs here are worn parts, leaks and corrosion. We test before we replace and answer the phone 24/7.
Call or text (669) 337-9311 · Get a phone estimate
Licensed CSLB #1008381 · Bonded & Insured · Open 24/7 · Navien Service Specialist · Rinnai PRO · Noritz Certified



How does Redwood City water affect water heater repairs?
Redwood City water is soft, which changes the repairs we make. All of the city's drinking water comes from the San Francisco Regional Water System, also called the Hetch Hetchy system (City of Redwood City). The SFPUC's 2025 report for that system lists an average hardness of 62 ppm, about 3.6 grains per gallon (SFPUC 2025 report).
Soft water leaves far less sediment than the 16.8 grain wells in San Jose. Tanks here rarely rumble. Instead we see worn igniters, thermocouples and gas valves, leaking fittings, and anode rods that have done their job and need to be replaced.
Common Redwood City repair calls
These faults come up most often in Mt. Carmel, Roosevelt, Friendly Acres and Redwood Shores homes.
| What you notice | Likely cause | What we do |
|---|---|---|
| No hot water, pilot will not stay lit | Weak thermocouple or dirty pilot | Clean the pilot, replace the thermocouple |
| Burner clicks but will not light | Igniter or flame sensor worn out | Test and replace the igniter or sensor |
| Rotten-egg smell in hot water | Anode rod reacting with the water | Swap in a different anode type |
| Drip at the top of the tank | Corroded nipples or flex connectors | Replace the fittings and connectors |
| Tankless error after a blend change | Flow sensor or inlet filter issue | Clean the filter, read the code, test the sensor |
| Condo heater leaking into a closet pan | Tank failure or a blocked pan drain | Find the source, clear the drain, advise on the tank |
Why does Redwood City hot water look discolored after a water main flush?
Discolored hot water after a city flush usually means sediment from the mains settled in your tank. Redwood City's own water-quality FAQ covers this case, where cold water runs clear but hot water stays tinted (City of Redwood City). Draining a few gallons from the tank usually clears it.
The SFPUC also changes its source blend for maintenance, and Redwood City posts those blend change notices. If a tankless unit acts up right after one, tell us the date; it helps us test the right part.
Our Redwood City repair process, step by step
We follow the same steps in an Emerald Hills garage or a Redwood Shores condo closet.
- Text a photo of the heater, its model plate and any error code to (669) 337-9311.
- We give a phone estimate and a time window for your 94061, 94062, 94063 or 94065 address.
- On site, we confirm the fault with gas, voltage, flow and pressure tests.
- You approve the price, then we repair it with a matching part.
- We restart the heater and check temperature, relief valve, straps, vent and drain pan.
Is it safe to keep using a water heater that is acting up?
Turn the heater off and call if you smell gas, see water coming from the tank body, or hear the relief valve spraying. For gas, leave the building and call PG&E or 911 from outside first. For a leak, close the cold-water valve above the heater and switch off the gas or breaker.
In a Redwood Shores condo, also tell your HOA if water reached a shared wall or ceiling. California requires 2 seismic straps on every water heater (California Seismic Safety Commission), which matters on hillside lots in Emerald Hills and Mt. Carmel.
Repair or replace: three questions we ask in Redwood City
The Department of Energy puts most storage water heaters at 10 to 15 years of life and many tankless units past 20 (Energy Saver Guide). Soft water does not stop a tank from aging, so we look at three things.
- How old is the heater, based on the serial number?
- Is the leak from a fitting we can replace, or from corrosion in the tank itself?
- Has the anode rod been replaced, or is it gone and the tank now rusting?
If a new heater makes more sense, we explain tank, tankless and heat pump options and the Bay Area Air District zero-NOx rule now set for January 2028 (Bay Area Air District).
How often should you check the anode rod in Redwood City?
Check the anode rod every 3 to 4 years in Redwood City, even though the water is soft. The anode is the part that corrodes so the tank does not. Draining a little water every 3 months is still worth doing, as the Department of Energy suggests (Energy Saver Guide). See anode rod replacement.
Water heater repair across Redwood City
We repair water heaters across Redwood City, from Downtown Redwood City and El Camino Real to Mt. Carmel, Emerald Hills, Friendly Acres, Centennial, Roosevelt, Stambaugh-Heller and Redwood Shores. We reach Redwood City by Highway 101 and Interstate 280 from our San Jose shop at 240 Bayview Ave. Nearby, we repair water heaters in Palo Alto and serve Menlo Park and Atherton.
Redwood City water heater repair FAQs
How much does water heater repair cost in Redwood City?
Water heater repair cost in Redwood City depends on the failed part, the type of heater and access, such as a condo closet or a hillside garage. Efficient Water Heaters, Inc. finds the fault first and gives you the price before any work. Text photos of the heater and model plate for a phone estimate.
Why does my hot water smell like rotten eggs in Redwood City?
A rotten-egg smell in hot water only usually comes from the anode rod reacting with the water inside the tank. It is common on soft water. Swapping to a different anode type and flushing the tank usually fixes it, and we can test the rod during a visit.
Is soft Hetch Hetchy water better for my water heater?
Soft water is better for sediment, since tanks in Redwood City rarely fill with scale the way South Bay tanks do. It does not stop corrosion, though. The anode rod still wears out, so check it every 3 to 4 years to protect the tank.
How often should I flush my water heater in Redwood City?
On soft water, a yearly flush is enough for most homes, plus draining a quart every 3 months. Flush sooner after a city water main flush leaves your hot water discolored, since that sediment settles in the tank.
How long does a water heater repair take in Redwood City?
Most tank repairs take 1 to 2 hours once the part is on hand. A gas valve or tankless board may need to be ordered, which can add a day. Condo installs with tight closets can take a little longer to reach.
Do you offer emergency water heater repair in Redwood City?
Yes. Our phone is answered 24/7. If you have a leak or no hot water, call (669) 337-9311 and we will tell you how to make the heater safe and when we can be there. If you smell gas, leave the building and call PG&E or 911 first.
Get a phone estimate for your Redwood City water heater repair
Call (669) 337-9311 or text photos of your water heater and model plate. You can check CSLB #1008381 on the state license site.
Call or text (669) 337-9311 · Get a phone estimate · Efficient Water Heaters, Inc. on Google Maps
