Pilot Light Repair • San Jose

Water Heater Pilot Light Repair in San Jose

Updated • By Joseph Castro, Owner • Licensed CSLB #1008381

If your San Jose water heater's pilot won't stay lit, the cause is almost always mechanical, not random bad luck — a tired thermocouple, a dirty orifice, or a draft finding its way into an older detached garage. Here's how to tell what's happening and what it takes to fix it for good.

  • Licensed CSLB #1008381
  • Same-Day Service When Available
  • Trucks Stocked With Parts
  • Thermocouples & Gas Valves On Hand
  • Upfront Diagnosis
  • 4.8★ from 370 Google Reviews
Technician repairing a water heater pilot light assembly in a San Jose home

What this service covers

We get pilot-light calls across San Jose every week, mostly on older Rheem and A. O. Smith tanks sitting in detached garages. These are the causes we find, in roughly the order we see them.

  • Worn thermocouple that no longer holds the gas valve open
  • Failed thermopile on a newer self-generating pilot system
  • Dirty pilot tube or clogged pilot orifice (dust, spider webs, lint)
  • Flammable vapor sensor lockout on FVIR tanks (fault codes or repeated shutoffs)
  • Draft or backdraft from a garage door, vent, or nearby window
  • Failing gas control valve that won't hold a pilot signal
  • Low incoming gas pressure from a partially closed shutoff valve
  • Worn piezo or spark igniter that won't produce a spark
  • Condensation or rust fouling the pilot assembly on an older tank

Symptom → Likely Part

Use the symptom to narrow down the likely part before you call.

  • Pilot lights but goes out when you release the knob → thermocouple or thermopile
  • Pilot won't light at all, no spark → igniter
  • Pilot lights fine but burner never kicks on → gas control valve
  • Pilot flame is small, yellow, or lazy → dirty orifice or pilot tube
  • Tank shuts down repeatedly with a flashing light → FVIR flammable vapor sensor
  • Pilot blows out on windy days in the garage → draft or backdraft issue

How to Safely Relight a Pilot (Once)

Only attempt this if there's no gas smell. If you smell gas, skip straight to the safety note below and call us.

1

Find the rating label

Every gas water heater has a relight procedure printed on or near the tank. Locate it before you touch the control knob.

2

Turn the gas control to Pilot

Set the dial to Pilot (not Off, not On) and wait about five minutes for any residual gas to clear the area.

3

Hold, ignite, and hold again

Press and hold the control knob, use the igniter button or a long lighter at the pilot opening, and keep holding the knob for 30–60 seconds after it lights.

4

Release and check the flame

Let go of the knob slowly. The pilot should stay lit with a steady blue flame. Turn the dial to On once it holds.

5

Watch it for a day

If it goes out again within 24 hours, or won't stay lit through the hold step, stop relighting it and call us — repeated attempts can mask a failing gas valve.

Parts on our trucks

  • Universal and OEM thermocouples
  • Thermopiles for self-generating pilot systems
  • Complete pilot assemblies, including FVIR sensor units
  • Piezo and spark igniters
  • Honeywell / Resideo gas control valves
  • Robertshaw gas control valves
  • Bradford White ICON system controls

Pilot Light Calls Across San Jose Neighborhoods

San Jose's older housing stock means a lot of water heaters sit in detached garages that weren't built with gas appliances in mind — gaps under doors, single-pane windows, and open vents all let in enough draft to snuff a pilot on a breezy night. Combine that with tanks that haven't had a thermocouple replaced in a decade, and pilot-light calls are some of the most common service requests we get across the city.

  • Willow Glen (95125): drafty detached garages with gaps under the door, frequent pilot outages on windy nights
  • Rose Garden (95126): older bungalows with original Rheem tanks and worn thermocouples
  • Alum Rock (95127): aging A. O. Smith units with dirty pilot orifices from years of dust
  • Cambrian (95124): 1960s-era garages with single-pane vents that let in drafts
  • Blossom Valley (95123): tract homes with gas control valves original to the home's construction
  • Repeated PG&E gas service interruptions in older neighborhoods can leave pilots out across several blocks at once

If your tank is still not heating after a relight, see our water heater not heating San Jose guide, or if the issue traces to the gas valve itself, read about gas valve replacement in San Jose.

City Overview • Santa Clara County

Water Heater Pilot Light Repair in San Jose, CA — At a Glance

San Jose is our home market — we run 15+ water heater jobs per week across the 95110–95148 footprint. Every era of San Jose housing has its own quirks: 1920s Willow Glen bungalows almost always need gas-line upsizing for tankless, Almaden Valley slab-on-grade garages have their own seismic strapping approach, and 1970s Evergreen tract homes commonly need code-correction work on venting and expansion tanks during any replacement.

Neighborhoods routinely serviced from our San Jose dispatch — spokes represent typical response corridors, not exact geography.

Permits pulled with

San Jose Development Services

Utility

PG&E gas & electric

Local climate

Mediterranean — mild winters, dry summers; garage tanks rarely freeze

Housing stock we work on

1920s Willow Glen craftsman • 1950s Cambrian ranch • 1970s Almaden tract • modern North SJ townhome

ZIP codes covered

  • 95110
  • 95112
  • 95116
  • 95118
  • 95120
  • 95124
  • 95125
  • 95126
  • 95128
  • 95129
  • 95131
  • 95135
  • 95148

Nearby landmarks

Santana Row • Downtown SJ • Almaden Lake

See all San Jose water heater services →

San Jose — Frequently Asked Questions

  • Which San Jose ZIP codes do you cover?

    Every San Jose ZIP from 95110 through 95148, including 95110 Downtown, 95112 Japantown, 95116 East San Jose, 95118 Cambrian, 95120 Almaden Valley, 95124 Willow Glen–Cambrian, 95125 Willow Glen, 95126 Rose Garden, 95128 Burbank–Valley Fair, 95129 West San Jose, 95131 Berryessa, 95135 Evergreen, and 95148 Silver Creek.

  • Do San Jose water heater jobs require a permit?

    Yes. San Jose Development Services requires a plumbing permit for every water heater replacement and installation — including like-for-like tank swaps. Inspection covers CPC 507.2 seismic strapping, expansion tank, T&P discharge, combustion air, and vent clearance. We pull the permit and coordinate the inspection.

  • How fast can you get to my San Jose neighborhood?

    Willow Glen, Cambrian, Rose Garden, and Downtown typically see a tech within 2–4 hours. Almaden Valley, Evergreen, Berryessa, and Silver Creek are on 3–5 hour windows depending on the day. Same-day is available across all 13 ZIPs when scheduling allows.

  • Do you understand San Jose's older housing stock?

    Yes. We work daily in 1920s Willow Glen craftsman bungalows with half-inch black-iron gas mains, 1950s Cambrian ranches with atmospheric-vent tanks in closets, 1970s Almaden tract homes with garage installs, and modern North San Jose townhomes with tankless conversions. Each era needs a different scope.

Thermocouple vs Thermopile vs Gas Valve

Typical symptom

Thermocouple/thermopile fix: Pilot lights, goes out when knob released

Gas control valve replacement: Pilot holds fine, but burner never fires

Part cost tier

Thermocouple/thermopile fix: Lower-cost, quick swap

Gas control valve replacement: Higher-cost, more involved

How we confirm it

Thermocouple/thermopile fix: Millivolt test at the thermocouple

Gas control valve replacement: Millivolt output checks out, valve still fails to open

Typical tank age

Thermocouple/thermopile fix: Any age — wears out over years

Gas control valve replacement: Often 10+ years, valve components corroding

Not sure which path fits your situation?

Call (669) 337-9311Get Phone Estimate

Brands We Service for Pilot Repairs in San Jose

Rheem, A. O. Smith, Bradford White, and State gas water heaters. For the bigger picture on your unit, see our water heater repair San Jose page or check whether you're dealing with a broader no hot water issue.

Smell gas near the water heater? Leave first, then call.

Do not attempt to relight anything if you smell gas. Leave the house, call PG&E's gas emergency line at 1-800-743-5000 or 911 from outside, and once it's confirmed safe, call us at (669) 337-9311 for the repair.

Service hub

Broader water heater pilot light repair coverage in San Jose.

Closest city pages

Nearest city hubs by drive time from San Jose.

Frequently asked questions

The leading causes are a worn thermocouple or thermopile that no longer senses the flame, a draft in a detached garage, or a dirty pilot tube. If it goes out repeatedly after one relight attempt, the part needs replacing.

Pilot Won't Stay Lit in San Jose?

Call (669) 337-9311 or text a photo of your water heater's rating label to (408) 470-0191. We'll tell you what part it likely needs before we even arrive.

  • Licensed CSLB #1008381
  • Bonded & Insured
  • Open 24/7

Navien Service Specialist · Rinnai PRO · Noritz Certified